Impact Bed Product Introduction
Impact bed is widely used for replacing impact idlers. It is composed of impact bars, and impact bar mainly use excellent high elasticity special rubber layer, fully absorbed the impact of the whereabouts of your material, greatly reduces the impact of the whereabouts of your material to the conveyor belt, truly improve the stress state of the blanking point. The using of special UHMW polyethylene polymer surface makes the coefficient of friction between conveyor belts and impact bars to a minimum, and also make it abrasion resistant. Impact bed’s using ensures force of the conveyor belts surface and surface contact uniform , which effectively prevent the belt longitudinal tear cause of conveyor roller’s fracture and fall off. At the same time, greatly reduces the belt longitudinal tear probability after penetrated by sharp instruments or sharp materials.
Impact bed can provide continuous support for belt conveyor, and impact tension is small without tear possibility; High strength steel structure bearing, high elastic engineering rubber absorb impact force, long service life, not easy to damage; Type T slot design, easy to maintain and replace; Angle adjustable impact bed bearing surface uniform, not easy to cause the belt conveyor running deviation; Without belt sagging part and not easy to cause materials scattered and binding.
1. No moving parts, reducing maintenance cost.
2. Absorb impact energy.
3. The tilt angle can smoothly guide the belt to avoid stumbling.
4. Suitable for all kinds of belt surface width and angle; can withstand strong shock.
5. Install quickly and easily, easy to check and update.
6. Device blanking point with conveyor belt , extend the life of the belt.
Impact bar is the most important part of impact bed. The higher impact bar elasticity, the better absorption of the falling material’s impact. Our company’s impact bed is made of ultra-high molecular weight polyethylene, its surface molecules is greater than five million and hardness is less than 55. Some companies’ propaganda has good indicators, but the rubber hardness is not up to the most basic, just about 75 degrees, this will leads to high friction coefficient, but can't maximum absorb impact, damage conveyor belt and reduce the service life of belt conveyor.
Applicable scope of transmission bandwidth(mm)
Impact bar length
Impact bar height specifications